Printer tab, check check extruder & bed temperature. Reply cye604 Additional comment actions Your best bet would be to ask the guys at Repetier. Click on the printer settings gears in the upper right hand area of Repetier. Reading the manual but not finding out much info on these details. The interface for RepetierServer clearly only shows extrusion based controls and settings, and I'm going to assume there's too big of a difference between moving a hotend and moving a laser. I also put the corresponding commands in the power off/on button commands as replacements for the gcode but unsure if that is even something I should be going. I also saw a :shutdown printer" command in there which I put in Power off but i'm unsure what must occur for these to even be triggered. I tried to set the gcode to run my new working power on command ( Power on) and connected repetier host but the printer did not come on so i'm sure that isn't how that works. mjpgstreamer preconfigured in a way that it autodetects new webcams and offers them at the bottom to copy url to settings. With that said, is using an end code in printer settings on Host the best way to do this or is there a way in server? I do see some event dependent stuff in there but I'm not sure how this are applied. You need a software providing the webcam stream as jpg or mjpg and enter the url in the webcam section in server. and Repetier-Host are easy to use and dont require much set up. Ok as a test I used the BCM pin # (2) rather than the GPIO pin (8) and that seemed to work using this new method in in global settings. Cat Gcode FileI think one of the main reasons the print turns out so well is that the. You will see a window like this: At the top you see a drop down box, with the currently selected printer. The biggest part are the print settings, these are subdivided into five tabs. Go to the menu Config->Printer Settings or klick the button. The configuration is split into two main parts. The second part are filament settings, which contain parameters influenced by the filament selection. For the API Key go to Global Settings Connectivity: Then enter a descriptive name for the printer, select the printer and Repetier as host type. You find your IP on the dashboard under Network. Now you need your IP address and API Key of your Repetier-Server installation. The biggest part are the print settings, these are subdivided into five tabs. Click the gear icon to add a physical printer. Certainly not faulting anyone/anything just want to figure it out. To define the parameters behind your configuration, click the Configuration button to enter the setup. To define the parameters behind your configuration, click the Configuration button to enter the setup. The script worked fine up until the last version of repetier server, this much I know for sure. Watch your printer working via webcam and create astonishing timelapse videos to share or control your prints.
0 Comments
Leave a Reply. |